EcoxGear GDI-EXEJ300, Руководство пользователя

Страница: 4 / 12

Bluetooth Pairing & Your Audio
Connecting With Bluetooth: Connect
To Your Smart Device & Play Audio
When your EcoJam is turned on, the
blue LED light on the top panel will
flash rapidly indicating the unit is
ready to pair.
Turn on Bluetooth on your Bluetooth
device (Smart Device) and set the device
in pairing mode. Available Bluetooth
connections shall appear. Select the
ECOXGEAR speaker from the list of
discovered devices on your Bluetooth
device. Wait for a few seconds until the
connection is completed.
NOTE: Bluetooth connection feature
is found in the Settings section of
most mobile phones and other
Bluetooth enabled devices.
When the ECOXGEAR selection is
made and the Bluetooth connection
is completed, your EcoJam will
announce: “Bluetooth connected”
3
Power ON, Battery,
& LED Status Indicators
Once fully charged, press the Standby
Power Button on your EcoJam.
You will see the green LED light & you
will hear an ascending bell tone.
IMPORTANT: Ensure the Main
Power Switch, located in the back
compartment under the cap, is set in
the Upper ON position. If the switch
is in the Lower OFF position, your
EcoJam will not be able to turn on
using the Standby Button.
NOTE: The LED battery level
indicators are located on the top of
the unit. Each LED represents 20% of
a charge, with 5 full LEDs indicating a
full charge.
Audio playback time over Bluetooth
connection is approximately 12 hours
at 75% volume.
2