ECOWITT HP2551, Руководство по эксплуатации

Страница: 84 / 90

84
Problem Solution
Bring the sensor array inside the house (you can
disconnect it from the rest of the sensors). The
LED next to the battery compartment will flash
every 16 seconds. If the LED is not flashing
every 16 seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the
polarity. If the sensor is flashing every 48
seconds, proceed to the next step.
There may be a temporary loss of
communication due to reception loss related to
interference or other location factors,
or the batteries may have been changed in the
sensor array and the console has not been reset.
The solution may be as simple as powering
down and up the console .
Replace the batteries in the outside sensor array.
With the sensor array and console 10 feet away
from each other, remove AC power from the
display console and wait 10 seconds. Re-connect
power.
Temperature sensor
reads too high in the day
time.
Make certain that the sensor array is not too
close to heat generating sources or strictures,
such as buildings, pavement, walls or air
conditioning units.
Use the calibration feature to offset installation
issues related to radiant heat sources. Reference
6.6.
Absolute pressure does
not agree with official
reporting station
You may be viewing the relative pressure, not
the absolute pressure.
Select the absolute pressure. Make sure you
properly calibrate the sensor to an official local
weather station. Reference Section 5.12 for
details.