HOW YOUR PURIFIER WORKS
The Purifier distils and turns ordinary tap water
into clean, clear purified water. Uses for purified
water include drinking, cooking, ice cubes, salt-
restricted diets, baby formulas, steam irons, photo
processing, cleaning contact lenses, autoclave,
ulstrasonic baths, dental chair-side water bottles
and rinsing instruments prior to sterilisation.
By heating water to boiling, the water is changed
to steam, which rises. As the steam cools and
turns back into water, it is collected in the carafe.
Impurities are left behind in the kettle.
Purified water will remain fresher-tasting if it is
kept tightly capped. Also shaking the carafe
before pouring will aerate the water and make it
taste better.
Order extra carafes from the outlet where you
purchased your water purifier (see page 7) so you
can chill one bottle of purified water while you
make more.
STOPPING UNIT DURING OPERATION (MODEL EWS-EU500/230)
1. Remove kettle.
2.
Unplug unit from outlet
ELECTRONICS (MODEL EWS-EU800/230)
Control Buttons
From left to right the control buttons are
‘START/STOP’, ‘HOUR’, ‘MINUTE’, and ‘DELAY’.
Time Setting
When the time is blinking in the display window
indicates that the supply voltage has been
interrupted. The time will continue to run but will
only appear continuously in the display window
after resetting.
Setting the time display:
Hours:
To move the hours upwards by one hour: press
the ‘HOUR’ button quickly once. To fast forward
the time: press for at least one second. After
completion the time display will blink for another 3
seconds before the time is finally set.
Minutes:
To move the minutes upwards by one minute:
press the ‘MINUTE’ button quickly once. To fast
forward the time: press for at least one second.
After completion the time display will blink for
another 3 seconds before the time is finally set.
12-24 Hour Mode
Pressing the ‘HOUR’ and ‘MINUTE’ buttons
simultaneously for 5 seconds enables change
over from 12 hour mode to 24 hour mode (or from
24 hour mode to 12 hour mode). Further change-
overs are only possible after 5 seconds (and only
when the ‘HOUR’ and ‘MINUTE’ buttons are
pressed as described above). In the 12 hour
mode the display shows AM or PM.
Setting the Delay Function/Checking Delay
Status:
The Delay Function allows the purifier to be
programmed to start at a later time, if needed.
Setting:
Press the ‘DELAY’ button once. The Delay Start
Time and ‘DELAY’ symbol appear in the display
window. The ‘Delay Start Time’ can be changed
as follows:
Hours:
Press the ‘HOUR’ button once, after
which the hour figure blinks for 3 seconds in the
display window. During these 3 seconds the
hours can be forwarded by one hour by pressing
the hour button once. By continuous pressing of
the button, the time can be fast-forwarded.
Minutes:
Press the ‘MINUTE’ button once, after
which the minutes figure blinks for 3 seconds in
the display window. During these 3 seconds the
minutes can be forwarded by one minute by
pressing the minute button once. By continuous
pressing of the button, the time can be fast-
forwarded.
If the time is correctly set, after 3 seconds the
time reappears with the ‘DELAY’ symbol in the
display. The ‘DELAY’ symbol indicates that the
delay time function is activated. To deactivate the
delay time function, press the ‘DELAY’ button
twice within a period of 3 seconds, or press the
‘DELAY’ button once while in the delay mode.
After completion, the ‘DELAY’ symbol will not
appear next to the time in the display window.
3
