eCOUNT Technology GmbH
Schatzbogen 60
D-81829 München
Tel.: 0049 (0)89 454571-0
Fax.: 0049 (0)89 454571-11
Technical
Specifications
16
6. Technical Specifications
These values were measured with OSD-Panel attached and without flatpanel and
backlight inverter.
-
Supply voltage at 25˚C :
Minimum supply voltage
+ 11,4 V DC / 22,8 V DC
Typical supply voltage
+ 12,0 V DC / 24V DC
Absolute Maximum supply voltage
+ 12.6 V DC / 25.2 V DC
-
Typical Input current at 25
˚
C:
CRTtoLCD-71- OSD-keypad, input signal SXGA:
TBD mA
CRTtoLCD-71- OSD-keypad, power down:
TBD mA
-
Supply voltage ripple:
100 mV peak to peak 0 – 20 MHz
VGA connector signals :
Sync input voltage low :
0.8 V
Sync input voltage high:
2.4 V
RGB input voltage:
0 – 0.7 V with 75 Ohm external
termination
RGB input current:
0 – 5 mA
-
Current Rating of Flatpanel Power supply (preliminary):
PANEL VCC Steady State 3V / 5V and 12V @ +-5% : 3A
PANEL VCC 5sec. -5% 3V3 @5,6A
PANEL VCC 5sec. -5% 5V @ 5,15A
PANEL VCC 5sec. -2% 12V @ 4A
Note: Output power without any switch or short circuit breaker
-
Temperature:
ambient:
0˚C – 60˚C (*1)
non operating:
-10˚C – 85˚C
(*1) The maximum operating temperature is the maximum measurable temperature on any
spot on the module surface. It is the user responsibility to keep this temperature within the
above specification.
-
Temperature gradient:
operating:
25˚C per hour
non operating:
40˚C per hour
-
Relative Humidity:
operating:
10% - 90% RH non-condensing
non operating:
5% - 95% RH non-condensing
-
Mechanical:
Shock:
5G/20ms square wave maximum
Vibration:
1G/0-600Hz, dwell not to exceed