Continued from previous page
INSTALLATION OF THE
TIR LENS
FOR THE RADION XR30w
View the video at www.ecotechmarine.com/tirlens/
DO NOT OVERTIGHTEN SCREWS. IT MAY STRIP SCREWS OR DAMAGE THE RADION.
ROUTE WIRES WITH SUPPLIED
WIRE TIES AND SECURE TO
FIXTURE WITH PHILLIPS
CORNER SCREWS (2).
(Wait to tighten screws.)
STEP 8:
LOCATE SUPPLIED WIRE
TIES (2).
>
>
STEP 9:
ROUTE WIRES NEATLY
ALONG INSIDE WALL
AND TIGHTEN SCREWS
ONCE PROPERLY SET.
STEP 10:
ENSURE LENS IS
ALIGNED AND PLACE
IT OVER CLUSTER.
(Adjust wiring if
necessary.)
STEP 11:
AFTER CENTERING TIR LENS
OVER LED CLUSTER, FASTEN
2.5MM SCREWS (4) INTO
HOUSING.
(Repeat this process
for second lens.)
STEP 12:
REPLACE RUBBER GASKET,
ENSURING THAT IT IS FULLY
ALIGNED AND SEATED FLAT
ON EACH CORNER.
STEP 13:
REPLACE ACRYLIC BOTTOM
PLATE AND ENSURE AN EVEN,
SNUG FIT.
(Serial number sticker
should be visible.)
STEP 15:
ALIGN FAN GRILL ASSEMBLY
(2 PIECES) AND FASTEN
PHILLIPS SCREWS (4) INTO
FAN HOUSING.
STEP 14:
FASTEN REMAINING PHILLIPS
SCREWS (4) INTO EACH
CORNER.
YOU HAVE SUCCESSFULLY UPDATED YOUR RADION XR30w WITH
TIR LENSES
.
Note: Upon completion of the TIR lens installation, you will no longer need original clear lens plates or reflectors.
The TIR lenses are thinner than the original reflector and plate assembly and will be recessed in the fixture.
As with the previous assembly, the TIR lenses make a water-resistant seal with the rubber gasket that was reinstalled in Step 12.
