Remark
ll
1.
When installation is completed, the batten light will start to work under automatic
mode as default setting.
2.
Manual mode allows daytime operation. In manual mode, light will turn OFF after 12
hours if not turned OFF manually.
3.
If the red light flashes once when you try to turn it ON, it means the battery is dead.
Make sure you charge it properly
INSTALLATION
HOW TO REPLACE BATTERY
SPECIFICATIONS
Size
LED
max
Max lumens
Battery
Solar
panel
Cable
IP Rate
360 mm
12W
1200 lm
3,7V
8,8 Ah
10W
6V
5,0 m
IP 65
600 mm
24W
2400 lm
3,7V
17,6 Ah
18W
6V
5,0 m
IP 65
For any additional information request or for any
problem with the product, please contact us
before returning it.
CONTACT INFORMATION :
Ecosolaris
622, Roland-Godard Blvd
Saint-Jerome (Quebec)
J7Y 4C5
1-800-966-7987
www.ecosolaris.com
3. Use 3mm hexagon
spanner to loose and
remove the two screws
1. Drill the hole for screws.
Screw diameter is 4 mm
2. Insert the screw cap into
wall and make it flat as
surface
3. Use screw driver to fix
the screws into the
wall/ceiling
4. Connect light and solar
panel with the DC solar
cable
5. Press button to turn ON
light
1st push: 100% power
2
nd
push: 50% power
3rd push: 30% power +
100% when sensor is
triggered
4th push : OFF
6. Disconnect the DC
connectors then take
out the battery carefully
1. Remove the bracket
from the side where there
are no buttons
2. Use clips or small tools
to take out the two
silicone plugs
4. Separate the end cap
from tube body (avoid
losing the waterproof
silicon ring)
5. Hold the battery cable
and take it out carefully
from light fixture until
you see the DC
connectors
7. Hold the cable
connector from light, and
insert battery properly,
then connect battery
cable to light cable by DC
connectors.
8. Put the end cap back
to tube body with silicon
wing at good position
9. Repeat the steps of last
operations
6 -> 5 -> 4 -> 3 -> 2 -> 1.
Tip : When new battery is connected to controller
successfully, the red light inside of motion sensor will start
ON for 2 seconds, then OFF.
6. Select AUTO or MANUAL
mode and set the lighting
program as you like
IMPORTANT
NOTE:
If your batten light does not light up during
daytime, please deactivate Automatic Mode
by pressing the ‘‘Auto’’ button on your
remote control.
