engLisH
Burner Assembly - Propane
PROPANe
1. unpack burner box. remove all items and check against the items
listed on page 9 of the manual to ensure all parts needed are ready.
2. ensure you have assembled the control panel, as outlined on page 10.
For the Round Burner go to step 4.
3. Linear burners only: (this step is not required for round burners)
attach the burner to the adapter plate (found inside the surround unit)
using the four bolts and nuts provided.. ensure burner is attached
to the flat side of the adapter plate marked “For Gas Burner Only”. If
experiencing issues lining up the holes of the burner and the adapter
plate, please rotate the burner 180 degrees and try again.
4. The flexible gas line is already attached to the burner orifice. Confirm
the air shutter is open
1
/
4
in (6.4mm) on each side of air shutter and
ensure connection of flexible gas line is tight.
5. ensure ignitor wire is secured to bottom of ignitor.
6. ensure grounding wire is secured to bottom of burner.
1/4”
(6.4)
7. Place a protective towel over the unit. Carefully place the burner
on Surround Unit near opening without inserting burner into the final
location. Feed the flexible gas line, grounding wire and the Ignitor wire
through the burner location and out the control panel opening of the
surround unit (located on the side of the surround unit).
8. slide the black propane tank hose under the surround unit and out
through the control panel opening. The other end of the black propane
hose with the regulator will attach to the propane tank.
9. Using two adjustable wrenches, attach the flexible gas line to the top
valve fitting (outlet). Do not overtighten.
10. Using two adjustable wrenches, attach the propane tank hose to the
bottom valve fitting (inlet). Do not overtighten.
