Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
8
2
2
Rod (2.5x300mm)
TP Screw (2.3x12mm)
Servo tray(70x58x2mm)
Pivot&round hinge(4.5X67mm)
8
Install the aileron servo to the servo mount as illustration
below.
Install the control horn and connect the linkage.
Make sure hinges are
mounted in the same line.
1mm
Trailing
edge
Cut away the rubber tube when
the epoxy glue dried.
Make sure they are in
the right position while
installing.
Aileron
Collar (2.5mm)
2
2
2
2
2
2
Screw (3x16mm)
Nut (3mm )
Clevis
Aluminum Washer (3x6mm )
Nut
Clevis
Washer 3x6mm
Screw 3x16mm
Collar
Control horn
8
pivot & round hinges(4.5x67mm)
Apply instant type AB glue to appropriate position in the
trailing edge and assemble the ailerons to them.
Apply instant type AB glue to appropriate position of the aileron and
pivot & round hinges. Insert the pivot & round hinges to the ailerons.
Keep about 1mm width space between the aileron and
the trailing edge.
Accessory list for the coming installation steps.
1
2
3
4
5
4
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x6mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Clevis
Washer(2x5mm)
Install the servo of the rudder.
The sketch map of how the steel wires works for the
rudder.
Epoxy the control horns to the slots in the rudder.
Nut 2mm
Washer(2x6mm)
Screw (2x16mm)
Lock the linkage to the control horn with screws and nuts
as below.
Assemble the servo of the rudder in the fuselage and
connect the servo and the rudder via steel wires.
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
The sketch map should be when the rudder and stabilizer
install completion.
A = A ’
B = B ’
A
A ’
B
B ’
Steel wire
Copper joiner
Aluminum tube
Clevis
28
29
30
27
31
32
9