The interior of The Ecomiser SR-02 / SR-03 models are made of quality stainless steel that has been
electro polished to make it the smoothest surface available. The smooth surface prohibits the
accumulation of dirt and bacteria inside the unit. If the water in your area is especially hard, however,
lime deposits could form inside the machine. If this happens, you can remove them by putting 1000cc of
scale remove aid in the wash tank and running a normal washing cycle 10 times. In extremely hard
water areas you may need to repeat this process a few times to remove hard water deposits.
CLEANING THE STRAINER BASKET
For your convenience, we have placed the strainer within easy reach inside the tub. To clean the
strainer, wash it gently in hot, soapy water and rinse it thoroughly 1 to 2 times everyday.
CLEANING THE DOOR
To clean the edge around the door, use only a soft warm, damp rag. To prevent penetration of water
into the electrical components, do not use a spray cleaner of any kind.
WARNING
Never use a spray cleaner of any kind on the control panel. You could damage the electrical
components. And never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Also, some paper towels can scratch or leave marks on the stainless steel surface.
CLEANING THE IMPELLERS
Impellers may sometimes become clogged with hard water deposits. To remove them, grip the center
of impeller and wash it all over with soft rags. After removing all of them, don’t forget to check
impellers and make sure it revolves easily.
DELIMING
Lime scale deposits will occur over time on the interior of the machine if it is operated using a hard
water supply. The Ecomiser SR-02 / SR-03 models recommend that a deliming or de-scaling process
can be used to remove these deposits, as well as any accumulated food residue. When deliming the
interior area, be sure to follow these guidelines.
- Use deliming agents designed for use with commercial dishwashers.
- Follow the instructions for the deliming agent that is used.
NOTE
After the deliming process
- Run the machine through 2-3 regular cycles and sanitize the interior thoroughly.
- Inspect the interior for any remaining deliming agent residue. If residue is present, remove it using a
soft cloth and hot water; then, run the machine through one final cycle.
- Press the POWER OFF button. This will empty the tank, ensuring that any deliming agent still in the
tank will be flushed out of the machine.
- Ensure that all residue of the deliming agent is removed. Residue from the agent can pose a health
hazard and damage seals and plastic components inside the machine.
Ecomiser SR-02 / SR-03 Manual 19/24 Page Rev.06