07
08
10. TEMPERATURE DEPENDENT OVERLOAD PROTECTION
When using as intended the power tool cannot be subject to overload. When
the load is too high or the allowable battery temperature of 75 C is exceeded,
the electronic control switches off the power tool until the temperature is in the
optimum temperature range again.
11. PROTECTION AGAINST DEEP DISCHARGING
The Li-ion battery is protected against deep discharging by the"Discharging
Protection System. When the battery is empty, the machine is switched off by
means of a protective circuit:
The inserted tool no longer start.
CHARGING & BATTERY
1. REMOVING THE BATTERY
If the Battery does not slide into the charger easily, do not force it. Instead,
slide the Battery out of the charger again, check the top of Battery and the tool
battery slot are clean and undamaged and that the contacts are not bent.
Setting up the battery charger.
1）. If fitted, remove any Battery(B )from the Battery Charger(A).
2）. Insert the Battery Charger mains plug into a suitable mains socket.
CHARGING THE BATTERY
Insert
battery
A
B
WARNING!
Use this charger only to charge the supplied battery or
additional purchased batteries that are specifically designed for this tool.
WARNING!
The charger is designed for indoor use only, and must not be
used in damp or wet conditions.
CAUTION!
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the plastic, and
make the plastic unserviceable.
CAUTION!
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING!
Remove the battery pack from the machine before
maintenance.
6. MAINTENANCE
WARNING!
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
7. CLEAN THE MACHINE
Use a moist cloth with a mild detergent to clean the machine.
Clean all moisture with a soft dry cloth.
Use a small brush to clean the air vents.
To increase the efficiency and life of the blades, lubricate them carefully after
each work session：
8. LUBRICATE THE BLADE
Put the machine on a flat and smooth surface.
Use a soft cloth to clean the blades and a brush to remove more dirt.
Use a light layer of oil to lubricate the blades along the top edge of the
blade.
Note： We recommend to use the non-pollutant type oil .
9. OVERLOAD PROTECTION
When overloaded, the motor comes to a stop.
Relieve the load on the machine immediately and allow cooling for approx. 30
seconds.
