© 2018 Ecolink Intelligent Technology Inc.
PN H114101
Door/Window Sensor Installation Instructions
Product Overview
Z-Wave Plus enabled device which provides open/closed position status
Transmits open/closed status
Reports tamper condition when cover is open
Product Specifications
For indoor use only
Operating frequency: 868.42, 869.85 MHz
Operation range: Up to 100 feet (30.5 meters) line-of-sight
Operating temperature: 0°
– 50°C, 32° – 122°F (ambient temperature)
Battery type required: 3V Lithium CR123A
Battery life approximately 3 years
Network Inclusion
The sensor must be added to a Z-Wave network prior to use. To include the
sensor in a network both the sensor and the network controller must be in
inclusion mode at the same time.
Refer to the instructions provided by the
manufacturer of your specific con
troller for details on initiating the controller’s
inclusion mode.
STEP ONE Start by placing the controller into inclusion mode.
STEP TWO Activate inclusion mode for the sensor by removing the plastic pull-tab from the back of the sensor. When the
inclusion process is complete, the LED on the sensor will be solid blue, then go out.
STEP THREE Test the sensor. Place the magnet next to the sensor to represent a closed position (see Installation section
to see where to position the magnet). If the LED flashes ONE TIME, it is successfully communicating on your
Zwave network. If the LED on the sensor flashes slow and steady for 5 seconds, you need to repeat the
inclusion process.
Notes: If you need to repeat the inclusion process, repeat STEP ONE above, then for STEP TWO you will need to simply remove the cover of the sensor, remove the
battery for 10 seconds, reinsert the battery, and replace the sensor cover. This will re-enter the sensor in inclusion mode.
Network Inclusion: Key Points to Remember
