Assembly Instructions
3
OFF ON
OFF ON
Fig. 5
Fig. 5
C
C
C
Insert 3 new alkaline C cell batteries (not included) into
the battery compartment and orient them with the “+”
and “-” markings on the back of the battery
compartment (
Fig.
5
). Re-attach the battery
compartment cover by aligning the legs on the lower
edge of the battery compartment cover onto the fixture
body and close the cover until the catch at the top
engages. Replace the screw. When ready to use, turn
the switch, located above the battery compartment, to
“ON”. Do not mix old and new batteries. Cold weather
may have a negative impact on battery life.
Attach the security light to the rear housing cover by
positioning the security light over the rear
housing cover at an angle. Engage the
security light into the grooves of the
rear housing cover and secure by
twisting clockwise until the
security light is seated vertically
(
Fig. 6
).
4
OPEN
LOCK
UPWARD
Fig. 6
OPEN
LOCK
UPWARD
The TIME control knob can be adjusted to control
the length of time the light stays ON when triggered
by the PIR sensor (
Fig. 4
). In the far left position (-),
the duration time is approximately 10 seconds. In
the far right position (+) the duration time is
approximately 30 seconds.
The SENS control knob can be adjusted to control
the range of the PIR sensor (
Fig. 5
). The far left
position (-) sets the PIR sensor range to
approximately 1 foot. The far right (+) sets the PIR
range to approximately 30 feet.
The LUX control knob can be adjusted for the
surrounding level of darkness needed to activate
the PIR (
Fig. 6
). This is quite variable. The far left
position (-) sets for maximum level of darkness (or
near full darkness). The far right position (+) sets for
minimum level of darkness.
Operating Instructions
The individual light heads can be adjusted side to
side and up/down independently to aim the light
heads in the direction desired (
Fig. 1
).
1
Fig. 1
The motion sensor can be rotated to position in the
direction of an area to be covered. If the 2 tick
marks are aligned, the motion sensor is focused
straight ahead. The motion sensor can be rotated
approximately 45 degrees right or left of center
(
Fig. 2
). The motion sensor has a maximum
detection field of 130° at a distance of 30 ft.
The control knobs for adjusting the operation of the
security light (TIME, SENS and LUX) are located on
the back side of the motion sensor. To gain access
to these controls, rotate the sensor clock-wise
(
Fig. 3
).
2
4
5
6
Fig. 2
3
Fig. 3
Fig. 4
Fig. 5
Fig. 6
SENS
TIME
L
U
X
SENS
LUX
Remove the security light from the rear housing
cover by gripping the fixture and turning counter
clockwise until the catches disengage from the
rear housing cover (
Fig. 1
).
Battery Replacement
The red LED low battery indicator on the front of the security light will light up when the
batteries are low and need replacing. Alkaline batteries can last up to 270 days if the
security light is activated for 10 seconds an average of 4 times per night.
1
OPEN
LOCK
UPWARD
Fig. 1
OFF ON
OFF ON
OFF ON
OFF ON
- 2 -
2
