Ecolab Elados EMP KKS E60, Руководство по эксплуатации

Страница: 263 / 406

14.6 Connector assignments / Control input and output
14.6.1 Pin assignment / conductor coloring Connector I (3-terminal)
Connector for low-level advance warning or empty report
Pos.
Conductor
coloring
Assignment
1 brown low-level advance warning
3 blue empty report
4 black GND
Ä
Chapter 7.2.2 ‘Connection assignments of Slolt I (3-terminal)
Input for low-level advance warning and empty report ’
on page 37 ).
WARNING!
In the event that the empty report is not used, contact 3/4 must always be
bridged! The protective cap provided for this
(
Ä
Chapter 7.2.1 ‘ Inputs and outputs’ on page 36 ) creates the bridge between
he contacts and must be attached in this case.
NOTICE!
The empty and reserve report input can be inverted in the "Configuration / Low-
level contact" menu. ( Ä Chapter 10.3.8 ‘Configuration / Low-level contact’
on page 76 ).
14.6.2 Pin assignment / conductor coloring Connector II (5-terminal)
Connector for pulse / standard signal input and metering lock
Pos.
Conductor
coloring
Assignment
1 brown Output 5 V, DC
2 white Pulse input
3 blue Input metering lock
4 black GND
5 grey Input standard signal 0/4 … 20 mA
Ä Chapter 7.2.3 ‘Connector assignment of slot II (5-terminal) Input
for pulse signal, standard signal, metering lock, batch and metering
monitoring ’ on page 39
NOTICE!
The metering lock input is only active if it has been previously set in
"Configuration / metering lock" menu
(
Ä
Chapter 10.3.7 ‘Configuration / Metering lock’ on page 75 ).
The batch function (
Ä
Chapter 10.3.15 ‘Configuration / Batch’ on page 93 )
and metering monitoring ( Ä Chapter 10.3.13 ‘Configuration / Metering
monitoring’ on page 82 ) must also be configured.
Technical Specifications
127 417101442 Rev. 12-02.2019