Ecolab 106052, Руководство по эксплуатации

Страница: 86 / 108

6.1 Function settings
Metering capacity setting
DANGER!
Before opening the pump, switch off (disconnect) the supply voltage and
ensure that it cannot be switched on again unintentionally!
1.
Ä
Chapter 5.1.1 ‘Separate back cover module from pump module’ on page 24 .
2. Set the jumper for capacity (
Ä
Chapter 4.1.2 ‘Pump module’ on page 22 , pos. J2)
depending on the current viscosity range and flow rate according to
Ä Table on page 31 , Ä Table on page 32 and/or Ä Table on page 32 .
The check LED lights only during the dispensing stroke.
The LED goes off during suction and when the pump is at rest.
Standard setting (maximum metering capacity: 20 l/h)
The pump is delivered in below described standard setting for:
low viscosity products (e.g. water).
Jumper Setting Metering Volume Setting - Potentiometer Setting
Jumper right side
Minimum Maximum
Metering capacity:
Infinitely variable from … up to … [l/h]
1 20
Suction stroke:
constantly [sec]
0,15
Pressure stroke:
Infinitely variable from … up to … [l/h]
6,5 0,18
Number of Strokes:
Infinitely variable from … up to … [l/h]
9 180
Max. Metering counterpressure:
[MPas (bar)]
0,2 (2)
Start-up Operations
31 Rev. 5-06.2018