ECOFOREST ecoSMART e-system, Руководство пользователя

Страница: 5 / 23

User manual ecoSMART e-system
3
EN
1.2. Steps to follow in case of fire
Electrical devices may ultimately cause a fire due to faulty installation or improper use of the equipment. The measures taken must
ensure the safety of persons in the first place, as well as prevent further material damage. In case of fire inside or near the
e-system ,
follow the instructions below:
-Disconnect the e-system and isolate it from the mains by turning off the magneto-thermal switch on the general switchboard,
downstream from your energy meter.
-The fire must be extinguished by means of convectional agents, as this is a system considered to be of low voltage, with output
voltages of less than 600Vac.
-In the event of a fire in the batteries, only dry powder extinguishers may be used. Liquid fire extinguishers are prohibited.
DANGER!
▪
Remember that, with the exception of small, localised fires, only the fire brigade is equipped and
authorised to intervene in fire-extinguishing manoeuvres. If the fire has spread, you must leave the site
and get to safety immediately.
1.3. Maintenance
The ecoSMART equipments do not require specific maintenance after commissioning. The internal controller monitors a large number
of parameters and will produce a warning if any problem arises, in which case we recommend you contact your distributor.
DANGER!
▪
All maintenance work must be performed by an authorised technician. Improper handling of the
equipment as a whole can result in personal injury and/or damage to materials.
▪
Do not spill water or other liquids directly on the device to clean it, as this could cause an electric shock
or fire.
▪
Do not manipulate or bypass the electrical protections of the devices. It could cause irreversible damage
to the equipment.
▪
Do not make any changes to the electrical connection and communication lines to the storage system
without the express permission of the manufacturer.