COMPONENT CHECKLIST
QUANTITY
DESCRIPTION
1
Burner tray assembly.
1
Stone effect body.
1
Bag of granular burner medium.
13
Individually packaged ceramic pebbles.
1
Set of manufacturers instructions.
1
Screw and rawlplug pack.
1
Fitting template.
INSTALLATION OF APPLIANCE
Notes: Ensure that the gas supply is isolated before commencing installation of the appliance.
Check that the thermocouple connection nut into the rear of the valve is secure.
Smoke test the flue to ensure proper draw and that there are no leaks present.
Locate the gas supply point. This appliance is suitable for all gas connections, including those concealed
behind the opening.
Using the fitting template provided mark out and drill
the position of the four fixing screws as required using
a 7mm masonry bit. These hole positions are shown on
the template together with the position of the inlet
restrictor elbow and the outer profile of the stone effect
body. IMPORTANT : The front face of the stone effect
body should be flush (i.e. on the same vertical plane) as
the fireplace opening when the appliance is installed in
it’s final position.
Insert the fibre rawlplugs into the fixing holes and then
using the fixing screws provided secure the burner unit
to the hearth/base of builders’ opening. Remove any
protective film from the lower decorative trim.
Using 8mm diameter pipe, connect the appliance to the
gas supply point. The appliance must be fitted with
rigid or semi-rigid pipe of 8mm external diameter. The
appliance is factory fitted with an inlet restrictor elbow.
Keep the amount of 8mm pipe used in the supply to a
minimum - less than 1.2m where possible. A long run
of pipe may cause an unacceptable drop in the supply
pressure.
The stone effect body of the fire is simply placed onto
the four supporting lugs and then sits under it’s own
weight. Similarly, the upper decorative trim sits on top
of the stone effect body. No additional fixing is
required.
FUEL BED LAYOUT
Please refer to the relevant section of the user instruc-
tions.
TESTING AND COMMISSIONING
Turn on and test the gas supply up to the fire for any
leaks, in accordance with current edition of BS6891.
When the appliance is first used, protective oils coating
the firebox may burn off. It is advisable to ventilate the
room during this period for at least one hour.
5
7.0
6.1
Securing the burner
Fitting the stone effect body
Fit the upper decorative trim
8.0
9.0
©
2009 Focal Point Fires plc.
