5
Portable Infrared Heater REM/RET
ECO CALORIA Sp. z o.o.
27-200 Starachowice, ul. Zgodna 2
Tel.: +48 41 274 14 41 fax: +48 41 273 71 47 [email protected] www.ecocaloria.com
Installation Instructions
Portable Infrared Heater REM
The support stand for the REM model is supplied in two halves for ease of packing.
1. Place the base half of the stand ‘A’ on the work surface.
2. Remove screws, nuts and washers from the base half of the stand.
3. Slide the top half of the stand ‘B’ into position by engaging the tabs into the slots on the base half as
shown in Fig. 4.
4. Line up the holes between the base half and top halves and replace the screws and washers on the outside
‘C’ and the serrated washers and nuts ‘D’ on the inside of the base and fully tighten as shown in Fig. 5.
5. Remove the four screws and washers ‘E’ from the back of the heater.
6. Place the heater against the top half of the stand and replace the four screws and washers ‘C’ and
ensure that they pass through the stand and fully tighten..
Fig. 4
Fig. 5
Fig. 6
’A’
’B’
’C’
’D’
’E’
’E’
