© 2020
-
03 EcoAir 6 All rights reserved
STEP 6
EMPTYING THE WATER TANK
The Water Full Indicator lights up when the water tank is full and the dehumidifier stops
operating.
Do not move the dehumidifier or remove the water tank when the dehumidifier is running,
as water may leak; causing damage to the dehumidifier or an electric shock.
Before removing the water tank leave the dehumidifier to stand for approximately 10
minutes to ensure all water has dripped into the water tank.
To remove the water tank, slide it out gently by gripping the water tank from bottom cuta-
way and pull out carefully.
Pour the water away by tilting the water tank, (see step 4 picture) to the right side. Clean
the water tank if needed.
Reinsert the water tank to the correct position, as soon as possible to prevent water drip-
ping from the dehumidifier.
Check the rubber plug is firmly in place. Insert the water tank back to the correct position.
NOTE :
•
Clean the water tank with clean water if needed. Do not use detergent, solvents, abra-
sives or hot water to avoid damaging the water tank or float.
•
Do not remove or damage the float in the water tank or the dehumidifier will not oper-
ate properly.
•
The Water Full light indicator illuminates if the water tank is not correctly in position.
•
Do not tilt the dehumidifier when removing the water tank.
•
If the water tank is removed whilst the dehumidifier is running the fan will continue to
run for 3 minutes.
Slide the water tank out
Lift by the handle
STEP 1
STEP 2
STEP 3
Pour the water away
Check the rubber plug
Restore the tank
STEP 4
STEP 5
