Eco Pure EPHY, Инструкция по установке и эксплуатации, Страница: 9 / 26

9
Installation Instructions
FIG. 13
Top Cover
Brine Tank
Overflow
Elbow
Brine Tank
Overflow
Grommet
2 cm Hole
Salt Lid
Salt
Storage
Tank
Float
Stem
Brine
Tubing
Brinewell
Cover
Stand
Tube
Brine
Valve
Brinewell
Nozzle & Venturi
Assembly
FIG. 10
Turbine Turbine Support Assembly
Valve Outlet
FIG. 11
Clip
Channel
Single Bypass Valve
FIG. 12
Correct Assembly
Clip
Outside diameter
of clip channel on
single bypass valve
Outside diameter of
water treatment sys-
tem valve inlet & outlet
NOTE: Be sure all 3 tabs of the clip go through the matching
holes on the water treatment system valve inlet or
outlet, and fully into the channel on the single bypass
valve. Make sure that the tabs are fully seated.
COMPLETE INLET AND OUTLET PLUMBING
Measure, cut, and loosely assemble pipe and fittings
from the main water pipe to the inlet and outlet ports of
the water treatment system valve. Be sure to keep fit-
tings fully together, and pipes squared and straight.
Be sure hard water supply pipe goes to the water
treatment system valve inlet side.
NOTE: Inlet and outlet are marked on the water treat-
ment system valve. Trace the water flow direc-
tion to be sure hard water is to inlet.
IMPORTANT: Be sure to fit, align and support all
plumbing to prevent putting stress on
the water treatment system valve inlet
and outlet. Undue stress from mis-
aligned or unsupported plumbing may
cause damage to the valve.
Complete the inlet and outlet plumbing for the type of
pipes you will be using.
COLD WATER PIPE GROUNDING
CAUTION: The house cold water pipe (metal only)
is often used as a ground for the house
electrical system, The 3-valve bypass
type of installation, shown in Figure 8,
will maintain ground continuity. If you
use a plastic bypass valve at the unit,
continuity is broken. To restore the
ground, do the following:
1 . Install a #4 copper wire across the removed section
of main water pipe, securely clamping it at both
ends (See Figure 14) - parts not included.
NOTE: Check local plumbing and electrical codes
for proper installation of the ground wire.
The installation must conform to them. In
Massachusetts, plumbing codes of
Massachusetts shall be conformed to.
Consult with your licensed plumber.
FIG. 14
Ground Wire
Clamp (2)