JINECO02 RevG 11/06/12
Assembly
Instructions
F
LUE
C
OLLAR AND
B
LANKING
Wind the eight M6 studs supplied into the fixing
holes in the flue collar and blanking plate until
finger tight.
Place a flue outlet gasket in position on the top
plate of the stove and lower the flue collar
blanking plate (as required) on to the stove top,
taking care to line up the studs with the fixing
holes.
Secure in place using the M6 nuts and washers.
Slide the remaining gasket on to the studs of
the flue collar or blanking plate and secure in
place on the back plate. Unless the optional flue
damper is being fitted, blank off the damper
handle holes in the flue collar using the two M8
coach bolts.
LANKING
P
LATE
Wind the eight M6 studs supplied into the fixing
holes in the flue collar and blanking plate until
Place a flue outlet gasket in position on the top
plate of the stove and lower the flue collar or
blanking plate (as required) on to the stove top,
taking care to line up the studs with the fixing
Secure in place using the M6 nuts and washers.
Slide the remaining gasket on to the studs of
the flue collar or blanking plate and secure in
ace on the back plate. Unless the optional flue
damper is being fitted, blank off the damper
handle holes in the flue collar using the two M8
Fire Bricks
The Fire Bricks, in this appliance, are factory
fitted. The following set of photos show
removal sequence that you will need to employ
when servicing your Hunter
Side Bricks
Remove all the Riddling Bars, Cam Bar and
Catch Bar.
Slide out both Side Plates.
The Fire Bricks, in this appliance, are factory
fitted. The following set of photos show the
removal sequence that you will need to employ
Hunter Stove.
Remove all the Riddling Bars, Cam Bar and
Slide out both Side Plates.