5
ASSEMBLY
1
Preparing to pump motor oil using
adapter and tube
Remove the dipstick from the engine/motor
from which you plan to remove motor oil.
Cut at a 60 degree angle one end of tube (A).
Lubricate the pump impeller by placing several
drops of mineral or vegetable oil on the
impeller at inlet port (1).
Place the adapter tube (B) into the inlet port (1)
of the pump (C) as far as it will go in.
Insert the end of the tube (A) with the
60 degree cut into the motor dipstick hole.
Attach the garden hose (D) to port (2).
Attach drill pump with tubes and hose to drill.
Connect drill motor power cord to a 3-wire
grounded plug.
Inspect the washer in the inlet hose to
make sure it is in good condition and installed
in the hose.
Lubricate the pump impeller by placing several
drops of mineral or vegetable oil on the
impeller at inlet port (1).
Connect hose (D) to the port and suction hose
to intlet port on pump (C) outlet.
Attach the drill pump with hoses to the drill.
Connect the drill motor power cord to a 3-wire
grounded plug.
NOTE: Motor oil should be removed when at
room temperature.
Ensure drill is not connected
to electrical service as you begin this process.
2
Preparing to pump clean water using
garden hose connected to pump
Ensure drill is not connected
to electrical service as you begin this process.
Keep the inlet hose as short
as possible
The combined height of the
inlet and outlet hose should be no higher than 3
ft. above the water source and/or not more than
25 ft. horizontally from the water source.
To minimize the pump rotating
as you start the drill.
To minimize the pump rotating
as you start the drill.
Ensure water is drawn into the
drill pump within 15-20 seconds to avoid damag-
ing the pump. If it does not, check to ensure the
pump (C), ensure none of the hoses are crimped
and that the suction hose is fully inserted in the
water source.
NOTE: Water should be removed when it is at
room temperature.
If water has suspended solids,
a strainer should be installed on hose (D )that is
in the water. A piece of door screen tied to end
of hose that is in the water would help keep any
solids out of the hose.
Ensure motor oil is drawn into
the drill pump within 15-20 seconds to avoid
damaging the pump. If it does not, check to
in pump (C), ensure the tube is not crimped and
that the tube is fully inserted in the dipstick hole.
C
B
A
1
D
A
B
C
D
1
D
C
1
2
2
1
C
Do not pump oil if debris /
metal shavings are present