BEFORE FIRST USE
Carefully examine the pump and all parts to ensure no parts
are damaged. If any part of the pump appears to be dam-
aged, do not use the pump and contact the
Customer
Service Team at 1-877-326-3561.
INTENDED USE
This pump is suitable to pump rain water and also can be
used both for permanent and temporary installation. The
pump can be placed in a sump pit to pump rain water con-
taining suspended solid particles 3/8 in. for EPC33 & EPC50
and 3/16 in. for EPP33 & EPP50 or less in diameter.
INSTALLATION REQUIREMENTS
Call an electrician when in doubt. Pump should be connected
to a separate 15 amp circuit breaker or 15 amp fuse block.
Note that plugging into existing outlets may cause low volt-
age at the motor. This could cause blown fuses, tripping of
the motor, overload or burned-out motor.
This pump is provided with an on/off float switch for
automatic operation. Refer to the Installation instructions
included with switches andcontrollers for installation.
Care should be taken to prevent the pump from running in a
dry sump.
Plastic PVC pipe can be installed in the outlet piping. Drain
hose, galvanized steel or copper pipe may be used if desired.
All piping must be clean and free of all foreign matter to pre-
vent clogging.
Before installing the pump, clear the sump basin of any
water, debris, or sediment.
g the pum
p, clear the sump basin
PRE-INSTALLATION
Pump
Float Assembly
Spare Float
Assembly
Parts
PACKAGE CONTENTS
MATERIALS REQUIRED (NOT INCLUDED)
Before using this pump, ensure you have the following items:
Inlet and discharge piping, Thread sealant tape, Check
valve, PVC glue and Sump basin
1
PREPARING THE PUMP
Remove the upper rubber grommet
(1) from the float assembly (B).
2
ATTACHING FLOAT ASSEMBLY
Insert the top of the float assembly (B) in
the switch arm hole. Slide the upper
rubber grommet (1) over the end of the
float assembly (B) to hold the float
assembly in place. Adjust the float
assembly per the dimensions in step 3.
3
ADJUSTING THE FLOAT ASSEMBLY
• Install the bracket (1) to the hole on the column
(A). Ensurethe pin on the bracket (1) is inserted in
the hole on the column (A).
• Adjust the lower rubber grommet’s position
(control switch ON). The grommet (2) should be
between 5.5 in. and 9 in. from the top of the rod.
• Adjust the upper rubber grommet’s position
(control switch
OFF). The grom
met (3) should be
2.3 in. from the
top of the rod.
ASSEMBLY
1
1
1
2
3
A
B
B
B
3
