15
Battery Break-In
To break in your new powerchair batteries for maximum efficiency:
1.
Fully recharge any new battery prior to use. This will bring the battery up to about 90%
of its peak performance level.
2.
Drive your powerchair for a small amount of time while you become accustomed to the
controls.
3.
Fully charge the batteries again for 8-12 hours and then operate the powerchair again. The
batteries should now perform at over 90% of their potential.
4.
After four or five charging cycles, the batteries will top off at 100% charge and last for an
extended period.
Charging Your Batteries
1.
Connect the charger port cable to the controller charging port on the front of the controller.
2.
Plug in the charger into an electrical wall outlet.
3.
Controller battery gauge will illuminate.
4.
Minimum charging time varies depending on battery condition and discharge level. It is
recommended to charge the batteries overnight.
5.
Once batteries are fully charged unplug the battery charger from outlet and then from the
controller. Do not leave the charger connected to the controller when the input power is
disconnected. It is dangerous and will jeopardize the power charging to the batteries.
The battery charger has an auto shut off when the batteries are completely charged.
A Guide to Safe and Lasting Batteries
1.
For longest life your batteries should be recharged after use, preferably overnight.
2.
If your Powerchair is not used for a period of time, a refreshing charge should be given every
month. Never leave your batteries in a discharged condition. This is particularly important to
sealed batteries.
3.
If your Powerchair has been stored away for some time, recharge your batteries before re-
using it.
4.
Every six months, check the connections on the batteries, making sure they are tight and
clean.
Batteries carry no warranty
