OPERATING INSTRUCTIONS.
Please check carefully before operating. Make sure the tool is complete and has no
damaged parts.
Please do not knock any part of the tool, otherwise it is dangerous
for operator.
1.
Select the appropriate die set for the connector and cable being used. Ask an
authorized facility or distributor to choose proper compression die set for the
connector and cable being used.
Don’t operate the tool without dies.
2.
Pull the limit pin to insert the upper crimping die and press the retaining clip to
insert the lower crimping die. The steel ball located center of the die will match the
die holder when both die halves are in place.
3.
Make sure both die halves are secured before operating the tool.
4.
Place the connector between the dies, turn the screw 180° to open the pump handle.
Pump the handle until the connector is held in place. In this process, spring loaded
pump handle automatically opens by itself for one hand pumping operation.
5.
Fully insert the cable into the barrel of the connector
6.
Continue pumping the tool handle to crimp the connector completely. The internal
relief valve will automatically activate when full pressure is reached. The handle
pressure decreasing is indicated by a significant clicking sound.
7.
Two stage pumping action with safety valve inside to control the crimping pressure.
The built-in safety valve is tested before shipment, the user can not adjust by himself,
please send the tool to the professional trained person to adjust, then use the tool.
Dust or air inside the tool will damage the sealing kit and cause the tool malfunction.
Make sure the oil is clear and no dust entering into oil when changing oil. Wait for a
while and exhaust the oil completely out of the oil tube before inserting the oil plug.
Please lock the handle to avoid air entering into hydraulic system when changing oil.
Please wear rubber gloves to avoid skin touching the oil directly, if it happens, please
wash the skin with soap and water quickly. In order to protect the environment
please drain the waste oil to the treatment center where was approved by government.
1. If the tool is not used for a long time, please make sure the piston stays in its original
position, Clean up the tool and rub rustproof oil both on the tool and the die. Put them back
into the box and store the tool in a dry surrounding.
2. The Sealing kit inside the tool will be abraded in some degree after use, when the oil
leaks a lot, please contact the distributor to replace the Sealing kit immediately.
TROUBLESHOOTING
FAULT ANALYSIS SOLUTION
A. No pressure or the
pressure is not enough
during operation
1. The pump lacks oil
2. There is dust/air in
oil
3. Inner leakage
1. Fill or replace the oil
2. Change the oil
3. Contact manufacturer or
distributor
B. Oil leakage on the
head or on the plunger
1. Sealing kit broken
1. Contact manufacturer or
distributor and replace it by
trained person