7
PANEL DESCRIPTIONS
6.1. Transmitter Frontal Panel and Rear Panel
1.
Power LED:
The LED illuminates red when power is applied.
2.
Test Pattern:
Pressing the button with paper clip or other pointed tool, the left
LED illuminates blue and the device generates an image of 1080P/60Hz color bar
to output; Pressing this button again, the left LED will blink blue at an interval of
500ms and the product generates an image of 4K/60Hz 4:4:4 color bar to output.
Press and hold this button for three seconds again can exit the Test Pattern mode.
3.
1080P
→
4K:
Press and hold the button at least three seconds with paper clip or
other pointed tool to enable 1080P to 4K up-scaling, and then the left LED
illuminates blue. Press and hold it again to exit.
4.
EDID:
4-pin DIP switch for EDID setting and HDCP mode selection. Please refer
to
for more details.
5.
FW:
Micro-USB port for firmware upgrade and user-defined EDID upload.
6.
HDMI In:
Type-A female HDMI input port to connect a HDMI source.
7.
ARC Audio Out:
Toslink connector to connect speaker or amplifier for ARC audio
output.
8.
IR In:
3.5mm jack to connect the IR receiver (not included) for IR pass-through.
9.
IR Out:
3.5mm jack to connect the IR emitter (not included) for IR pass-through.
10.
RS232:
3-pin terminal block to connect the RS232 control device (e.g. PC) or a
third-party device to be controlled.
11.
HDBT Out:
RJ45 port to connect the HDBT input port of receiver by CATx
Ethernet cable. The LINK LED illuminates orange when there is a valid HDBaseT
link between the transmitter and the receiver. The HDCP LED illuminates green
when the video contains HDCP content.
12.
DC 24V:
DC connector for the power adapter connection.
Tx
Rx
LINK
HDCP
1
2
3
4
5
6
7
8
9
10
11
12
HDBT Out
HDMI In
IR Out
IR In
ARC Audio Out
