9
4.5
DIGITAL AUDIO INPUTS AND OUTPUTS
VIDA
allows the reception of 4 channels of digital audio DANTE
™
and the sending of
4 channels of digital audio DANTE
™
through an Ethernet network compatible with the
transport of digital audio over IP through the DANTE
™
protocol.
The routing of the digital audio signals DANTE
™
through the Ethernet network, as well as
the network configuration of the ports DANTE
™
(IP addresses, mask, etc.) of the VIDA, is
managed by the software application Dante Controller.
For more information, please refer to the developer's documentation:
www.audinate.com/products/software/dante-controller
4.6
AMPLIFIED OUTPUT CONNECTIONS
The rear panel is fitted with
two position screw terminal block for each amplified output
.
Always
respect the relative polarity for outputs
(+ and
–
on each output connector),
wiring and speakers.
4.6.1
OUT MODE
Allows
configuring each amplified output, individually
, to operate with high or low
impedances.
Select the appropriate operation mode to do not damage the loudspeakers.
Never
connect loads below 2 ohms when working in low impedance mode
.
Make sure to match the impedance of the total load connected to the
loudspeakers
, when working in low impedance for a correct performance. If impedance
values do not match, select the closer one above.
