10
4.6.2
OPERATION EXAMPLE
AMP
OUT1
: HIZ-100V
AMP
OUT2
: HIZ-70V
When
HIZ is selected
, 2ohm switch
has no effect.
AMP
OUT3
: LOZ-8ohm
AMP
OUT4
: LOZ-2ohm
When
LOZ is selected
, and 2ohm
switch is in 2ohm position (down), switch
4/8ohm has no effect.
The connection cable that joins the amplifiers outputs and the loudspeakers
must be of good quality, sufficient section and as short as possible
. This is most
important when the distances to cover are long ones i.e., up to 10 meters it is
recommended to use a section not inferior to 2.5mm2 and for superior distances 4mm2.
4.7
AUXILIARY OUTPUT CONNECTIONS
VIDA rear panel provides
two analogues, balanced, line level auxiliary outputs.
Their
independent routing, mixing, and processing is performed from VIDA embedded web
application.
Please refer to the web application manual for more information on
Signal input connectors are 3 position screw terminal block. The wiring is:
For
unbalanced connection
short-circuit pin
to pin -.
•
If an auxiliary output is connected to an amplifier or audio device with a balanced
input, all terminals must be connected point by point and between the two devices.
•
When connecting an output channel to an amplifier or device with an unbalanced
audio input, leave the
–
terminal unconnected.
Vivo o señal directa > Pin +
Frío o señal invertida > Pin -
Masa
> Pin
