6
The AUDEO SB110P control panel also features the following user controls:
•
PHASE: 0° / 180°. This switch allows you to invert the phase of the input
signal, so that output signal phase can be aligned with signals produced by
the other system speakers.
•
VOLUME: Control for adjusting the input signal attenuation. The 0dBV central
position corresponds to the nominal equipment sensitivity.
An internal low-pass filter is incorporated to the AUDEO SB110P for the unit to work on
a selected sub-bass frequency range particularly suitable for combination with other
AUDEO series speakers.
PLACEMENT AND INSTALLATION
Please observe the following general rules:
•
As a subwoofer, the AUDEO SB110P has been designed to be installed in discrete
places. Low frequencies are considered to be non-directional so the AUDEO
SB110P can be perfectly placed in corners, under a table, behind curtains... that
will not notably affect its output. Generally, it should be known that placing it close
to various surfaces will increase its efficiency. Consequently, the sound pressure
level will be higher if you place the speaker on the ground in a corner rather than
just beside a wall and even more that in the centre of a room.
•
There is no rule governing the number of mid/high speakers per subwoofer. It
mainly depends on the subwoofer location and on the room acoustics. Thus, in a
highly reflective room, a subwoofer may even damage intelligibility while several
subwoofers could be necessary in a room with highly absorptive surfaces.
•
Always place the speakers on solid and firm surfaces.
•
Adapt the sound pressure levels to the diffusion needs.
