EchoStar PVR-5020, Руководство пользователя

Страница: 3 / 64

Safety Guidelines
www.echostar-int.com Page III
©
20
04
Ech
o
S
tar
In
te
rn
ati
o
nal
C
o
rp
or
at
io
n
Al
l ri
g
h
ts
r
e
s
e
rv
e
d
SAFETY GUIDELINES 1. I
NTENDED USE
This documentation set is intended for anyone
who uses an EchoStar receiver. It can be used
by both first-time and experienced users of
receivers who want to install, use and maintain
their receiver.
This User guide is applicable for the
EchoLITE PVR receivers and is divided into
separate sections and chapters. For easy
access to the information, a clear table of
content is provided.
Note that this manual is applicable for all
models, therefore the most comprehensive
description and operation is given. For detailed
information, please refer to your dealer.
2. N
OTATIONAL CONVENTIONS
Throughout this user guide, there may be
blocks of text indicated by symbols and printed
in a different way then the surrounding text.
These blocks of text ask the attention of the
reader to avoid hazardous situations. The
hazard levels are indicated as:
T
HIS WARNING INDICATES A HAZARDOUS
SITUATION WHICH
,
IF NOT AVOIDED
,
COULD
RESULT IN
(
SERIOUS
)
INJURY
.
This caution indicates a situation which, if
not avoided, could damage the equipment
or other properties.
This note indicates additional information to
make you aware of possible problems and
information of any importance to help the
you to understand, to use and to maintain
the installation.
3. G
ENERAL
S
AFETY
Read this user guide carefully and make sure you understand the instructions given. For your
safety, know what the reaction upon each action will be. Do not perform any actions which are not
described in this user guide, failing to do so might result in an uncontrolled behavior of the receiver
or even in a hazardous situation for persons and/or equipment.
Disconnect the receiver from the mains before you start any maintenance or installation
procedures. Do not use alcohol or ammonia based liquids to clean the receiver. If required, clean
with a soft lint-free cloth slightly made damp with a mild soap solution.
Consult an authorized service technician if the receiver does not operate normally when the
instructions in this user guide are strictly followed. Do not to attempt to open the receiver, as you
will be exposed to a shock hazard.
To avoid the risk of electrical shock and fire, do not put any objects on top of the receiver which:
■
contain liquids, such as vases, glasses, bottles, etc.;
■
contain an open heat source or open fire, such as candles, cigarettes, ash trays, etc.;
■
could fall through the ventilation slots or which could cover them and prevent proper cooling of
the components inside.
Make sure that nothing rests on the receivers cables and that the cables are not located where they
can cause injury to persons and pets (e.g to stumble over, eat the cable).
Do not install the receiver:
■
in the open air;
■
in a closed or poorly ventilated cabinet;
■
directly on top of or under another equipment;
■
on a surface which will obstruct the ventilation slots.
Do not expose the receiver and it’s accessories:
■
to rain or excessive moisture to avoid the risk of shock or permanent damage to your receiver;
■
to direct sunlight, heaters, stoves or any other heat generating equipment;
■
to any magnetic objects, such as speakers, electric motors, transformers, etc.;
■
to excessive vibration.
To help avoid possible damage to the receiver’s electronics, wait 5 seconds after you switched off
the receiver before you move the receiver or disconnect any equipment.
For receivers with conditional access capabilities:
■
do not put any foreign objects into the Common Interface (CI) slots or smartcard reader;
■
do not touch the components or pins on the CI-module/smartcard;
■
hold the CI-module and the smartcard by its edges.