EchoStar D-2400 IP, Руководство пользователя

Страница: 65 / 92

Troubleshooting
Section 7
Digital Satellite Receiver
Page 7 - 3
©
2
002
E
c
hoS
tar
Inte
rnati
o
nal
C
o
rp
orat
io
n
A
ll
ri
g
hts
re
s
erved
7
5. INSTALLATION RELATED
Problem Possible cause What to do?
1. My television does not
receive any signal from
the receiver (UHF only)
■
You did not select the
correct audio/video
channel on your TV.
■
Refer to the user manual
of the TV for instructions.
■
On the receiver, In the TV
system menu select the
correct channel and PAL
setting.
■
Use another method to
connect the receiver.
2. My television does not
receive any signal from
the receiver
■
You did not select the
correct A/V channel on
your TV.
■
Select the correct A/V
channel on your TV.
■
You did not use a correct
SCART cable.
■
Use only a full featured
SCART cable that is
correctly shielded.
3. My television shows black
areas on the left and right
of the screen.
■
You did not select the
correct aspect ratio for
your TV.
■
On the receiver, in the
user profile menu select
the correct aspect ratio.
4. In a motorized installation,
the dish turns to the West
while I select Set East
Limit.
■
The motor turns the other
way around because the
cable is not installed
correctly.
■
At the receiver, change
the cable connections to
M1 and M2.
5. In a motorized installation,
I cannot select a specific
satellite.
■
The required satellite is
located outside the
selected East or West
limit.
■
If physically possible,
mind dish damage, revise
the limit setting.
■
Select another satellite.
6. In a motorized installation,
the positioner reacts
unpredictable which
results in incorrect
positioning of the dish.
■
The cables used are
worn, damaged or
corroded.
■
Inspect the cable for
possible damage and
install new cable as
required.
■
The cable is incorrectly
finished or not sufficiently
shielded.
■
Use sufficiently shielded
and correctly finished
cables.
7. During (initial) setup of
the receiver, no channels
are found.
■
You did not select the
correct LNB(F).
■
On the receiver, in the
installation setup menu
select the correct LNB(F).
■
When installed, you have
selected the incorrect
switch type or port.
■
On the receiver, in the
installation setup menu
make the correct
selections.
■
You have selected the
incorrect satellite to
search channels on.
■
On the receiver, in the
installation setup menu
select the correct satellite.
■
You have selected the
incorrect search method.
■
At an initial setup, always
choose the option All.