9
Installation Guide
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (US)
email - [email protected] (Europe)
Front Application
For front applications,
SSM-DIS
must be used.
This system is fully automatic. It is on when the vehicle ignition is on. It is active
when the vehicle is below the set speed and is in standby mode when the vehicle is
above the set speed. The system should beep once when powered on to notify the
driver that it is on and working.
When the unit detects an obstruction the display (SSM-DIS only) will illuminate.
Additionaly, as the obstruction gets closer the user will be alerted via a series of beeps
that will increase in frequency together with more segments being illuminated on the
display.
The display will also show which side the object is (left or right) by using that sides
corresponding LEDs. Depending on whether the obstruction is at the front or the rear
of the vehicle the corresponding arrow will illuminate on the display. The top arrow
signifies a front obstruction and the lower one a rear. If an obstruction is present at
both the front and rear of the vehicle then the display will alternate between the two.
If no movement is detected for 2 seconds then the audible alert will be muted but the
visual alert will remain active. If movement is then detected again, audible and visual
alerts will resume.
To turn off the alerts press the external override button once. To reactivate, press
the button again. This feature can be useful in stop start traffic to avoid unnecessary
alerts. The kit will reset to standby mode once the vehicle has surpassed the set
Combined Application
If combining 2 kits into a complete front and rear parking solution then the buzzer
does not need to be installed as both kits will work with the one single display which
includes a buzzer. This buzzer can be turned off by briefly pressing the button on the
back of the display.
Operation will be as per the individual front and rear applications.
Note that when combining 2 modules into a complete kit, one of those modules
must include a display (SSM-DIS).
SSM-RBP / SSM-DIS
Parking Sensor System
with Buzzer or Display