3
Installation Guide
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (US)
email - [email protected] (Europe)
2
Installation Guide
tel - 1-800-477-2267 (East Coast) - 1-888-883-2790 (West Coast)
email - [email protected] (US)
email - [email protected] (Europe)
Fitting Instructions
Introduction
Box Contents
Key Features
u
Volume Control
u
Sensitivity setting
for mounting at various heights
u
Self-learning sensors
u
Number plate frame with 3 sensors
u
Control Module
u
Speaker
u
Power Harness
Congratulations on purchasing EchoMaster parking sensors. This
ultrasonic detection system is designed to assist in the avoidance of
obstacles while reversing.
Disclaimer:
EchoMaster® is strictly a driver assistance device, and should not be relied upon as a substitute for
safe driving practices. Use common sense when parking and always follow recommended safe driving
guidelines. To help prevent accidents, always use caution when parking, looking visually to ensure your
path is clear. Keep speeds under three miles per hour. The owner shall not be entitled to recover from
the Company, its successors or assignees, incidental and consequential damages, such as personal
injury, loss of income, loss of time, loss of profits, loss of vehicle use or property damage. No employee,
agent or representative of the Company of the Selling Retailer may modify, alter or extend this Warranty
in any way. This Warranty gives you specific legal rights. You may also have other rights under this
Warranty which may vary from state to state.
Note: Under no circumstances should you attempt to open the control box or any other component.
Doing so will void all manufacturer’s warranties.
SS-NP2
Rear EU Number Plate Sensor System
SS-NP2
Rear EU Number Plate Sensor System
Remove the number plate from the vehicle.
Drill 10mm hole for the grommet to allow cables to pass through.
Attach the number plate frame to the vehicle.
Note: When installing the frame, note the orientation sticker on the back of
the frame.
Slide number plate into bottom of frame and secure with the 3 clips on top.
Connect the red lead to Reverse light (12V) and the black lead to Ground.
Mount the speaker in the vehicle (clean mounting surface with alcohol swab)
and connect to the control module.
Connect sensors to the control module and mount in vehicle.
To set the sensitivity according to the number plate height, use the 3-position
switch on the control module.
Switch Position
Height
1
35-40cm
2
40-60cm
3
60-80cm
Height is measured from the middle of the sensor to the ground.
