3
Installation Guide
email - [email protected]
tel - 866-931-8021
Fitting Instructions
PMON-7022-AHD
7” Dash Mount 2 Input AHD Monitor
Choose a suitable mounting location dependent on the application.
This location should not interfere with the driver’s normal vision of the road.
Ensure that there are no wiring harnesses or hoses/pipes located behind this
panel before drilling any holes.
Tape the mounting area using masking tape and then mark the mounting
holes with a pen. You can also mark the hole for the cable entry at this time if
required.
Drill the mounting holes and cable entry holes.
If the cable passes through any metal then the hole should be protected with
a suitable rubber grommet.
Mount the monitor bracket and run the cable through the grommet.
Loosely attach the monitor to the bracket with the supplied bolts but do not
tighten until the image has been checked to ensure the correct viewing angle.
Make all required connections as per the wiring diagram in this manual.
Verify that the image is correct and that the viewing angle is good.
Secure all bolts.
