10
Installation Guide
10
tel - 1-800-477-2267
email - [email protected]
Illustrations are typical and may not match exact vehicle detail
Step 7
Using the zip tie secure the module to the sub dash center
support.
Interface Connections (continued)
Step 8
Remove the access panels just below the dash by pulling
the door seal back and pulling the panels towards the
rear of the vehicle.
Step 9
Using a large cable tie or dash snake, route the
camera harnesses from behind the radio to where
you removed the access panel in step 8. Once the
camera extension cables are routed, connect the
radio side of the cable to the corresponding left /
right input on the modules camera harness.
Be sure
when routing the cables, any and all moving
parts or sharp edges are avoided.
FCTP-MB1903
Sprinter Tow Package
