echoflex Elaho E-VAC-SR, Руководство по установке

Страница: 8 / 12

Echoflex Installation Guide
Vacancy Sensor
DIP Switch Settings
DIP switches on the sensor electronics provide for additional configuration
options including Use Custom Config, Vacancy Timeout, Enable/Disable PIR
detection LED, and the ability to restore the sensor to its factory defaults.
Switch # Use
1 Unused (leave Off)
2 Enable/Disable Custom Config Mode
•
When “Custom Config” is set to Off (also known as Basic
configuration mode), local DIP switch settings for Vacancy
Timeout and Enable PIR LED are used. See
Configuration
on page 9
.
•
When “Custom Config” is set to On, all other local DIP
switch settings are ignored. Instead, the settings made by
the ElahoAccess App are used.
3 and 4 Vacancy Timeout
•
5 min = Switches 3 and 4 are Off
•
15 min = Switch 3 is Off and Switch 4 is On (default)
•
30 min = Switch 3 is On and Switch 4 is Off
•
Auto = Both switches are On (See Vacancy Timeout on
page 10 .)
5 PIR Detection LED
•
When set to On (default), the occupancy detection LED
illuminates the lens when movement is detected.
•
When set to Off, the occupancy detection LED is disabled
unless the unit is in Walk Test mode.
6 Unused (leave Off)
7 Unused (leave Off)
8
Restore to Defaults at boot
•
When set to On and power is cycled to the sensor, the
unit restores to its factory default settings.
•
Off is the default setting.
Vacancy Sensor Page 8 of 12 Echoflex