![background image](http://html1.mh-extra.com/html/echo/power-pruner-ppt-2100-type-1-1e/power-pruner-ppt-2100-type-1-1e_operators-manual_3996801012.webp)
12
1.
POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Starter.
2.
THROTTLE TRIGGER - Spring loaded to return to idle when released. During acceleration press trigger gradually for
best operating technique.
3.
SHOULDER HARNESS - An adjustable strap that suspends the unit from the operator.
4.
CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.
5.
CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerate
and lower saw chain into branch.
6.
GUIDE BAR - 254 mm (10 in.) guide bar (PPT-2100), 305 mm (12 in.) guide bar (PPT-2400).
7.
SAW CHAIN - 91 VS 9.53 mm (3/8 in.) low profile Oregon® saw chain. Runs approximately 609.6 m/min. (2000 ft/min) at
full throttle.
8.
AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.
9.
LOWER SHAFT TUBE - Durable fiberglass mesh housing.
10. STOP SWITCH - Mounted on top of handle assembly. Move switch forward to run, back to stop.
11. THROTTLE TRIGGER LOCKOUT - This lever must be depressed before throttle trigger can be operated.
12. REAR HANDLE ASSEMBLY - Sturdy handle for right hand placement. Includes stop switch and throttle trigger.
13. ARM REST - Provides arm rest during operation and protects arm from hot engine.
14. MUFFLER, SPARK ARRESTER - The muffler controls the exhaust noise while the spark arrestor prevents hot, glowing
particles of carbon from leaving the muffler where they could possibly start a fire.
15. RECOIL STARTER - Pull recoil handle slowly until starter engages, then quickly and firmly. When engine starts return
handle slowly. DO NOT let handle snap back or damage will occur.
16. FUEL TANK - Contains fuel and fuel filter.
17. FUEL TANK CAP - Covers and seals fuel tank opening.
18. PRIMER BULB - Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming the carburetor
for starting. Pump the bulb 10 times until fuel is visible in clear fuel return line.
19. AIR CLEANER ASSEMBLY - Contains replaceable air filter element.
20. CHOKE - Located above air cleaner housing. Controls operation of choke. Move lever to start position (Close Choke)
and back to run position (Open Choke).
21. SPARK PLUG - Provides spark to ignite fuel mixture.
22.
GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar cover
before using unit.
23. OPERATOR'S MANUAL - Read and understand this manual before operation. Keep manual in a safe location for future
reference, i.e., operation, maintenance, storage and specifications.
24. SAFETY MANUAL - Read before operation and keep in a safe place for future reference to learn proper, safe operating
techniques.
Содержание Power Pruner PPT-2100 TYPE 1/1E
Страница 2: ......
Страница 11: ...POWER PRUNERTM OPERATOR S MANUAL 11 1 12 11 10 2 3 9 14 15 16 17 18 19 20 21 13 8 7 6 5 4 22 23 24 ...
Страница 34: ...34 NOTES ...
Страница 35: ...POWER PRUNERTM OPERATOR S MANUAL 35 NOTES ...