Echo PE-311, Руководство оператора

Страница: 9 / 28

P
OWER
E
DGER
O
PERATOR
'
S
M
ANUAL
9
__ 1 Power Head
__ 1 Drive Shaft Assembly
__ 1 Operator's Manual
__ 1 Safety Manual
__ 1 Warranty Registration Card
__ 1 ECHO Emissions and Warranty Statement
__ 1 Echo Power Blend
TM
2-stroke oil sample
__ 1 Front Handle
__ 4 5 x 35 mm screws
__ 1 Lower Bracket, Front Handle
__ 4 5 mm nuts*
__ 1 T-Wrench (Combination Spark Plug Socket/Screwdriver)
__ 1 Cotter pin 2mm x 25mm
__ 1 4 mm Hex Wrench
__ 1 Locking Tool
__ 1 8 mm x 10 mm Open-end Wrench
__ 1 Safety Glasses
* 5mm nuts may not be needed.
C
ONTENTS
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
__ 1 Edger Assembly
A
B
B
A
SSEMBLY
Tools Required: 4 mm Hex Wrench, 8 x 10 mm Open-end Wrench
Parts Required: Power head, Drive Shaft Assembly
DRIVE SHAFT
/
POWER HEAD
1. Stand power head upright on a level surface.
2. Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft
clamp, and remove center drive shaft location bolt (A).
3. Carefully fit driveshaft assembly to engine making sure that
inner drive shaft engages clutch mount.
4. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (A).
NOTE
Gear Housing must be aligned properly with engine. Aligning
center locating hole in driveshaft housing with center drive shaft
bolt (A) provides correct alignment.
5. Tighten two (2) drive shaft clamp bolts (B) securely.
A