Echo PE-266, Руководство оператора

Страница: 13 / 36

PE-266/S ASSEMBLY
X7502026302
13
© 3/2013 ECHO Inc.
ASSEMBLY
Drive Shaft/Power Head
1. Stand power head upright on a level surface.
2. Loosen the two (2) drive shaft clamp bolts (B) at engine
drive shaft clamp, and remove center drive shaft location
bolt (A).
3. Remove dust cap and carefully fit drive shaft assembly to
engine making sure that inner drive shaft engages into
clutch mount.
4. Turn drive shaft housing until locating hole lines up with
location hole in clamp and install center drive shaft location
bolt (A).
Note: Gear Housing must be aligned properly with engine.
Aligning center locating hole in driveshaft housing with center drive shaft bolt (A) provides correct
alignment.
5. Tighten two (2) drive shaft clamp bolts (B) securely.
6. Route throttle linkage and ignition lead assembly along shaft
and clip as shown.
Throttle Linkage and Ignition Leads
1. Close choke and remove air filter cover.
2. Place throttle linkage (C) through adjustment fixture (D) and
install wire end into large carburetor throttle swivel hole (E).
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. The
throttle linkage must be adjusted by moving the adjustment
fixture (D). Consult with your Echo Dealer for correct
adjustment procedure.
Parts Required: Power Head, Drive Shaft Assembly
A
B
A
B
C
D
E