PE-2620/S
OPERATION
X7502350201
23
© 06/2018 ECHO Inc.
4.
Loosen adjustment knob (A).
Move wheel (B) up to increase
cutting depth, or down to
decrease cutting depth. A depth
of 0.5 in. (13 mm) is optimal.
Tighten adjustment knob (A).
5.
Before edging, plan your
direction of travel so that the
unit will always be positioned
on your right side and so that
you walk on a hard surface
whenever possible.
6.
Position edger as shown.
Before edging, be sure to read and understand the entire
Operator's Manual to avoid serious injury.
7.
When starting to edge, run the engine at full throttle, and lower the
blade gently into the ground, being careful not to hit the concrete with
the blade.
8.
Don't force the blade. Move only as quickly as the blade will allow.
The complete unit, specifically the drive shaft
assembly and muffler exhaust area may
become very hot during use. Avoid contact
during and immediately after operation, otherwise serious
personal injury may result.
A
B
