![background image](http://html1.mh-extra.com/html/echo/pe-261/pe-261_operators-manual_4016397010.webp)
10
A
SSEMBLY
DRIVE
SHAFT
/
POWER
HEAD
Tools Required: 4 mm Hex Wrench
Parts Required: Power Head, Drive Shaft Assembly
1.
Loosen, the bolt (A) at engine drive shaft clamp.
2.
Carefully fit drive shaft assembly to engine making sure that
inner drive shaft engages into clutch mount.
NOTE
Lower gear housing and head assembly must be in line with the
engine.
3.
Turn drive shaft housing so that center line of housing is midway
between the two arrows on shaft.
4.
Tighten bolt (A).
THROTTLE
LINKAGE
AND
IGNITION
LEADS
1.
Close choke and remove air filter cover.
2.
Loosen nut (A) and place threaded end of throttle linkage in
bracket slot. Finger tighten nut (A).
3.
Place inner cable in slot of carburetor swivel (B) and tighten nut
(A).
4.
Check throttle for freedom of movement and that wide open throttle
/ low idle extremes are adjusted properly. If adjustment cannot be
achieved with adjusting nuts, consult with your Echo Dealer for
correct adjustment procedure.
5.
Connect ignition stop leads (C) and (D).
6.
Bundle and secure ignition leads against engine housing with clip
(E).
7.
Install air filter and cover.
A
A
C
A
B
D
E
Содержание PE-261
Страница 25: ...POWER EDGER OPERATOR S MANUAL 25 NOTES...
Страница 26: ...26 NOTES...
Страница 27: ...POWER EDGER OPERATOR S MANUAL 27 NOTES...