14
Before you start
Before you start
Assembly
Install blower pipes
1.
Place guide loop across elbow clamp, and turn until clip fully
engages clamp band.
2. Assemble clamps onto both ends of flexible pipe.
3. Assemble swivel pipe into flexible pipe and tighten clamp.
4. Loosen knob on handle. AIign notch in handle with tabs. In-
stall onto swivel pipe past long ridges in pipe.
5. Insert anti-static wire through flexible pipe.
6. Assemble flexible pipe to elbow on blower. Position guide
loop on outside of flexible pipe (away from blower) and tight-
en clamp.
7. Clip throttle cable into throttle cable guide loop.
8.
Position handle for comfortable operation, and tighten knob
hand tight.
9. Assemble straight pipe onto swivel pipe, until you feel light
resistance. Do not force connection. Hold swivel pipe and
turn straight pipe clockwise, engaging positive locking chan-
nels,until connection is firm. Do not force connection.
10. Assemble straight pipe with decal to straight pipe as in step
9.
WARNING
Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
1. Guide loop
3. Flexible pipe
2. Two clamps
4. Swivel pipe
NOTE
Clamp with cable guide loop fits elbow end of flexible pipe.
1. Handle
3. Swivel pipe
5. Anti-static wire
2. Knob
4. Clamp
6. Elbow
NOTE
A light lubricant may be used to ease assembly of flexible pipe
to blower elbow.
NOTE
Hang handle freely from blower to assure throttle cable is not
twisted before installing handle.
1. Throttle cable
3. Knob
2. Guide loop
1. Swivel pipe
3. Straight pipe
2. Straight pipe
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosen-
ing occurs, remove two straight pipes and install according to
instructions 9 & 10.
