OPERATION
PB-760LN
26
X7531125905
© 10/19 ECHO Incorporated
Starting Cold Engine
• Recoil starter: Use short pulls - only 1/2- 2/3 of rope length for starting.
Do not allow the rope to snap back in. Always hold the unit firmly.
• (PB-760H): Rotate spring loaded throttle arm downward to a comfortable
operating position.
1.
Throttle Position Lever
Move throttle position lever (A) to
IDLE position.
2.
Choke
Move choke (C) UP to COLD
START (
) position.
3.
Purge Bulb
Pump purge bulb (D) until fuel is
visible. Pump bulb an additional 4
or 5 times.
4.
Recoil Starter
Pull recoil starter handle (E) until engine fires, or a maximum of 5 pulls
5.
Choke
After engine fires (or 5 pulls), move choke lever back to RUN (
)
position, then pull starter handle/rope until engine starts and runs. Allow
unit to warm up at idle for several minutes.
Note: If engine does not start with choke in “RUN” position after 5
pulls, move choke to COLD START (
) position, and repeat
steps 4- 5.
6.
Throttle Position Lever
Allow engine to warm up for several minutes before use.
7.
Throttle Position Lever
After engine warm-up, move throttle position lever gradually to increase
engine RPM to desired operating speed.
PB-760 H
PB-760T
A
A
C
E
D
