24
sharpenIng
blades
Level 2.
Tools required:
(2) 10 mm Sockets & Extensions , Flat file, Screw
-
driver
Parts required:
None
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.
1. Clean dirt from the grease fitting (A).
2. Carefully pump grease into fitting (A).
DO NOT
force grease. Too
much pressure will force grease past seals and cause damage. Apply
1-2 pumps of grease every 15-25 hours of operation.
3. Wipe excess grease from around grease fitting.
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Remove blade stiffener (see “Blade Stiffener Remove/Install in-
structions”).
4. Slide blades to allow file clearance using slots (A) on bottom of
blade. Do not pry against cutting edges.
5. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used
DO NOT
allow blade to over heat.
6. Install blade stiffener (see “Blade Stiffener Remove/Install instruc-
tions”).
7. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
A
A
45
º
A
6mm (.25 in.) Radius
