Echo DIRECT VENT GAS HEATER, Инструкция по установке и эксплуатации

Страница: 33 / 45

ECHO DIRECT VENT GAS HEATER
33
PRE-START UP CHECKS

DO NOT use tools to operate controls. Only use
your hand to push in and turn the controls.

DO NOT abuse glass doors by striking or
slamming shut.

DO NOT try to repair the appliances. Call a
qualified service technician.

DO NOT clean the appliance when hot.

DO NOT use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the appliance and
replace any part of the gas control system which
has been under water.

DO NOT use this appliance if you smell gas.
WHAT TO DO IF YOU SMELL GAS

Open windows.

Do not touch any electrical switch.

Do not use the phone in your building.

Extinguish any open flame.

Immediately call your gas supplier from a
neighbor’s phone and follow the gas supplier’s
instructions

If you cannot reach our gas supplier, call the fire
department.
NOTE : The copy in manual is for reference only. In
the event of a discrepancy, the label on the unit is to
be taken as the latest version.
Wall Thermostat Control (Millivolt Thermostat
Mandatory)
Hook thermostat wire (2) to the terminals as
indicated in Figure 21, if you choose the wall
thermostat option. Keep in mind the heater will run
until the thermostat signals it is too hot in the room.
It will then turn the heater to pilot only. Location of
the wall thermostat is crucial. If it is too close to the
heater, the unit will shut down frequently. If it is too
far away, the heater will run longer than may be
necessary. Place the wall thermostat approximately
twelve (12) feet from the heater.
NOTE : Remove small wire shunt before hooking
up wires.
1. Push the gas control knob in slightly and turn
clockwise to the “Off” position. NOTE: The
knob will not turn from “On” to “Off” unless
the knob is depressed. Do not force!
2. Wait five (5) minutes to clear out any gas, then
again smell for gas, including near the floor. If
you smell gas, STOP and follow the
instructions outlined at the beginning of this
manual.
If you do not smell gas, proceed as follows:
1. Set the thermostat to the lowest setting (if
applicable).
2. Turn off all electrical power to the appliance
(i.e., unplug the room fan cord).
3. If you do not smell gas, turn the gas control
knob counter-clockwise to the “Pilot” position.
WARNING:
FOR YOUR SAFETY, READ BEFORE
LIGHTING
If you do not follow these instructions exactly, a fire or
explosion may result causing property and/or personal
injury.
Do not operate appliance with the glass front removed,
cracked, or broken. Replacement of the glass should be
done by a licensed or qualified service person.