Echo CSG-7410, Руководство оператора

Страница: 21 / 36

21
CSG-7410
Stopping Engine
Release throttle trigger and allow engine to idle.
Push the momentary stop switch.
The engine stops with just one press of the stop switch. It is not necessary to hold the
switch until it stops.
If engine does not stop, pull choke control knob out fully to stop engine. The choked
engine will slow to a stop. Be sure to keep the wheel in the clear until all movement stops.
RUNNING
1. Once the engine starts, allow it to warm up for 2 to 3 minutes at idling (i.e.
low speed).
2. Warming the engine helps to lubricate its internal workings more smoothly.
Allow the engine to warm up fully, especially when it is cold.
WHEN THE ENGINE IS WARM
1. Fill the fuel tank with fuel mixture. It is not permitted to fill fuel above the
shoulder level of fuel tank.
2. Press the decompression device.
3. Securely hold the engine cut-off saw. Pull starter grip briskly, but only 1/2
to 2/3 its full length. Pulling rope to the end may damage the starter.
* If the engine is hard to start, pull the choke to engage the fast idle throttle
latch setting, then return the choke to its normal position (this opens the
throttle slightly).
If it still fails to start, revert to the WHEN ENGINE IS COLD starting
procedure.
WARNING
With trigger latched, wheel will rotate as soon as engine starts. Keep
wheel in the clear.
Wheel will rotate for some time after the trigger is released. Keep
wheel in the clear until all movement stops.
Starter grip
Choke
Momentary stop switch
Choke
WARNING
Momentary stop switch automatically returns to run position. Engine
can start unintentionally when starter handle is pulled. Always
remove spark plug lead from spark plug before pulling starter
handle, otherwise severe personal injury may result.
Dust Suppression
WARNING
Do not use with wheels that are not designed to be used with wa-
ter-flush cutting.
Doing so may damage the wheel while it is being used.
1. Use water-flush cutting when doing work that generates a lot of dust, such
as cutting concrete.
2. Attach a water hose with a coupler on it to the joint of the engine cut-off
saw.
3. Make sure the liquid cock is in the closed position before turning the water
faucet on.
4. Adjust the water flow with the liquid cock.
5. After cutting, turn off the water and let the wheel spin itself dry.
IMPORTANT
Make sure there are no water leaks before use.
Use as little water as possible to sufficiently suppress generation of dust.
Open
Close
Coupler