4 English
OPERATION
WARNING
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
CAUTION
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Return the charger and battery to your nearest
service center for service or replacement.
NOTICE
Charge in a well-ventilated area. Do not block charger
vents. Keep them clear to allow proper ventilation.
Diagnostic Feedback
See Figure 1, page 7.
LEDs provide feedback to indicate whether the battery pack
is charging, fully charged, or defective.
Wall-Mounted Charging
See Figure 2, page 7.
The charger can be wall-mounted by the key-hole hangers
on the side of the charger. It can be mounted underneath
a workbench or table using the hangers behind the latch.
Make sure to mount the charger on a wall stud.
Screws should be installed so that the center distance is 4 in.
Cord Retainer
See Figure 3, page 7.
To keep the cord out of the way, the cord can be inserted
in one of the two retaining areas on the foot of the charger.
Charging
See Figure 4 - 5, page 7.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
them before first use. If the charger does not charge your
battery pack under normal circumstances, return both the
battery pack and charger to your nearest repair center for
electrical check.
Charge time is dependent upon the type of battery pack.
CBP-58V20
charges in approximately 30 minutes.
CBP-58V40
charges in approximately 60 minutes.
Make sure the power supply is normal household voltage,
120 volts, AC only, 60 Hz.
Connect the charger to a power supply.
Attach the battery pack to the charger by aligning the
grooves in the battery with the raised ribs on the charger,
then slide the battery pack onto the charger.
Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
WARNING
Make sure the latch snaps in place and the battery pack
is fully seated and secure in the battery port before
charging. Failure to securely seat the battery pack could
cause the battery pack to fall out, resulting in serious
personal injury.
Do not place the charger in an area of extreme heat or
cold. It will work best at normal room temperature (32ºF
to 120ºF).
The battery pack may become slightly warm to the touch
while charging. This is normal and does not indicate a
problem.
After charging is complete, the green LED will remain on
while the charger is in Energy Save Mode.
Charger will periodically wake from Energy Save Mode to
ensure the battery pack remains in a fully charged state.
To remove the battery pack from the charger, press the
battery latch button and pull the battery pack out using
the handle.
Charging a Hot Battery Pack
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly onto
the charger port but charging will not begin until the battery
temperature cools to within acceptable temperature range.
When a hot battery pack is placed on the charger, the red
LED will begin flashing and the green LED will be off. When
the battery pack cools, the charger will automatically begin
charging.
Charging a Cold Battery Pack
A cold battery pack may be placed directly onto the charger
port but charging will not begin until the battery temperature
warms to within acceptable temperature range. When a cold
battery pack is placed on the charger, the red LED will begin
flashing and the green LED will be off. When the battery
pack warms, the charger will automatically begin charging.
