Echo 99944200661, Руководство по установке

Страница: 1 / 12

C
ontents
1 U-handle assembly
1 Lower U-handle bracket (2 halves)
1 Harness clamp w/ring
1 5 x 18 mm bolt
1 8 x 55 mm bolt
1 Circular washer
1 Square nut
2 Throttle cable clips
3 5 x 30 mm bolts w/ washers
1 Shoulder Harnesss
1 Hip Pad
I
NSTALLATION INSTRUCTIONS
U-HANDLE KIT P/N 99944200661
X7502098901
X750004521
09/10
WARNING
You must install a Barrier Bar or U-Handle Kit and all Blade Conversion parts shown in the following instruc-
tions before operating this unit with blades, otherwise serious injury may result.
IMPORTANT
If non-standard monofilament heads, METAL/PLASTIC blades or cultivators etc., are used, THE CARBURETOR
MUST BE RESET or serious engine damage can occur. See "Carburetor Adjustment" in the unit Operator's Manual.
For Models:
SRM-260/260S S/N ALL
SRM-261/261S S/N ALL
SRM-260/261SB S/N ALL
SRM-261T S/N ALL
SRM-310/310S S/N ALL
SRM-311/311S S/N ALL
PAS-260 S/N ALL
PAS-261 S/N ALL
TO USE
THESE BLADES
Pro Maxi-Cut
Grass/Weed
Blade
Rigid Plastic
Tri-Cut
Grass/Weed Blade
Metal Blade
Loop Handle, w/or
w/o Barrier Bar
U-Handle or Loop Handle
w/Barrier Bar
U-Handle or Loop Handle
w/Barrier Bar
Plastic Shield Plastic Shield Metal Shield
Harness Harness Harness
Upper Plate &
Flat Washer
Upper Plate
& Glide Cup
Upper/Lower
Blade Plates
Hex Nut Hex Nut Hex Nut
You
must
install
these
parts!
New Cotter Pin New Cotter Pin New Cotter Pin
• WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
• Arbor diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
• Brush Cutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
BLADe set-UP GUIDe