ECG MK 092, Инструкция по эксплуатации, Страница: 35 / 56

35
EN
2) Hot air exhaust tube kit and device installation
1. Pull out the end of the hot air exhaust tube by turning it several times;
2. Hold the handle at the end of the C clip with your left hand and the short exhaust tube with your right
hand, place one end of the exhaust tube, which is disconnected, on the latch of the lower air inlet bottom,
press the exhaust tube clip fi rmly with your left hand so that the exhaust tube latches onto the latch joint
of the back cover (see fi g. 3).
Note: The end of the hot air exhaust tube must reach the stops within the lower air inlet bottom (see fi g. 4).
The tube shall be inserted onto the latch on the lower air inlet bottom by turning the end of the hot air exhaust
tube several times. The C clip, which clips the exhaust tube, must be fi rmly clipped to the back cover and the
hot air exhaust tube.
Stop position
of the lower air
inlet bottom.
Joint of the
lower air inlet
bottom
Fig. 3 Fig. 4
3. Hold the device in one hand and the short exhaust tube connector in your other hand; two people
may also collaborate, where one person holds the device and the other pulls the hot air exhaust tube,
essentially extending the tube by a slight margin.
Note: Do not separate the hot air exhaust tube kit from the device and do not tilt the device when tearing off
the exhaust tube.
3) Window sealing insert kit installation
1. Open half of the window and insert the sealing insert kit into the window, either vertically, or horizontally
(fi g. 5 and 6).
2. Move the sealing insert kit components away from each other, adjust the distance of the kit so that both
ends touch the window frame, and fi xate the kit using copper screws.
Fig. 5 Fig. 6