English
English
21
1
Step 1: Turn the filter counterclockwise and then
slide it out.
2
Step 2: Push the flat filter upward.
Note:
•
When removing the filter, proceed from step 1 to step 2, when inserting the filter back, proceed from step
2 to step 1.
Filter assembly
Regular filter cleaning ensures optimum performance and washing results. The filter effectively captures
particles from the wash water and allows the recycling of water during the cycle. It is therefore advisable after
each wash cycle to remove from the filter larger trapped particles by rinsing the filter under running water.
Remove the filter by pulling the tab of the filter in the vertical direction. The whole filter should be cleaned
once a week.
Use a cleaning brush to clean the coarse and fine filter. Then reassemble the filter as shown above and insert
the entire filtration system into the dishwasher back into position and push it downward.
WARNING!
•
The dishwasher must never be used without a filter!
Improper insertion of the filter may reduce the
performance of the appliance and damage dishes and utensils.
•
Do not tap on the filter when cleaning it. Deformed filter negatively affects the functionality of the
appliance.
Cleaning of the spray arms
Regular cleaning of the spray arms of chemicals from hard water is
important because emerging limescale clogs jets and bearings. You
can remove the spray arms by unscrewing the nut at the top of the
arm in a clockwise direction, then you can remove the arms. Rinse
spray arms in warm, soapy water and using a soft brush clean the jets.
After thorough rinsing put the arms back.
Caring for the dishwasher
Clean the control panel using slightly wet cloth. Dry thoroughly after
cleaning.
For the maintenance of the exterior use high quality polishing wax.
Never use sharp tools, abrasive powders or aggressive cleaners to
clean the dishwasher.
Frost protection
If the dishwasher is left in the winter in an unheated place, do the
following:
1. Disconnect the dishwasher from power.
2. Close the water supply and disconnect the hose from the water supply.
3. Drain water from the water supply hose and water valve. (Use pot to catch the water.)
