26
EN
Warning!
Before you start with the system installation, disconnect the terminal on the negative battery pole. See the
your car manual for detailed instructions.
Front assembly according to the DIN standard (Method A)
1. After removing the old car stereo and its
mounting frame, slide in the mounting frame
supplied with this system.
2. Pull out the latches on the mounting frame to
secure the mounting frame fi rmly in place.
System attachment
3. Connect the stereo connector with the car wires.
See the wiring diagram. Slide in the car stereo
into the dashboard. Then mount the exterior
panel.
4. Fix the stereo using the supplied back mounting
screw and steel strip. See list of components.
Back assembly according to the DIN standard (Method B)
Note:
The exterior panel, frame and metal strip are not used for the method B installation.
1. Remove the frames on both sides.
2. Align the screw holes in the frame supplied with the car and the holes for the stereo screws. Tighten two
screws on both sides of the system. Then fi x the frame to the car.
3. Connect the car wires to the stereo connector, see wiring diagram.
Frame supplied with car
Dashboard or console
Holders
